Regulating transformer Rectifier
The robust rectifier which is also suitable for aggressive ambient conditions.
The basic rectifier design of the regulated transformer rectifier series is characterized by a motor-adjustable regulating transformer drive and a high-current transformer with downstream silicon diode set in 6-pulse circuit.
Individual devices from:
- UDC = 0 - 1.500 V
- IDC = 100 - 20.000 A
Technical Data
- Mains: 3 x 400V/50Hz (worldwide network adaptation possible)
- Regulating: via binary more/less signal
- Setting range: stepless electronic 0...100%
- Signals: current, voltage, status, fault (individual fault messages optional)
- Control: interface via 16-pin Harting connector
- Ripple: approx. 5% at regulated full-DC-output voltage (optional with smoothing)
- Rectifier connection: 6-pulse rectifier-connection (optional 12-pulse)
- Operating mode: 100% duty cycle
- Ambient temperature: +35°C (higher temperatures conditions possible)
- Cooling: natural convection or oil/water cooling
- Detection: phase position; phase sequence; phase failure; mains undervoltage; short-circuit detection; temperature
- Degreee of protection: IP54
Options
- Field-bus interface (Profibus; Profinet; Modbus; RS-485 etc.)
- Additional motor controller: setpoint 0-10V, 4-20mA, 0-20mA
- Mechanical change of output polarity (bipolar operation)
- Transformer taps
- Smoothing devices (L and LC smoothing up to 1% possible)
- Ah-counter-integration
- Remote control (optional with timers or SPS control)
- Special designs according to customer requirements possible without any problems
Oil cools and protects
- Intensive cooling of components
- Protection against corrosion
- Outdoor installation also possible
- No noise pollution
- Low maintenance and reliable